You will need:
- A Base (slotta or not) - I am using a slotta base in this example
- A square of nylon window screen
- Super/Krazy Glue
- Tape - if using a slotta base
- Hobby Knife
- Nail Clippers
- Sand Paper - not pictured
Step 1 - If using a Slotta Base...
you need to cover the slot. Take a piece of tape (I just used some packing tape that was handy) and cover the hole. Next, take your knife and cut off the excess, leaving the hole covered, like so:
Step 2 - Take the Nylon Window screen...
and lay it across the base. Take the Super/Krazy Glue and apply it liberally to the base. We want to cover the entire base.
Step 3 - Trim the excess screen away, by....
Flipping the base over and using your knife to cut away the excess. Try to get as close as possible; although you can leave some excess behind.
Step 4 - Painting the base...
Is the last step. If you used a slotta base, flip the base upside down and prime it black. This will blank out the clear tape used in step one. Next prime the top with black, and dry-brush. I used a three color scheme that uses 1) Neutral Gray 2) Dove Gray 3) Sand. You can use whatever colors you like. (Note, I've since added Burnt Sienna for a rust effect)
Here are several repainted/rebased Clicky mini on home-made Diamond Tread base:
Based on a 1" Fender Washer
Based on 25mm Round Slotta Bases